Installation Process

Instructions to install the armor:

The piece that has stickers attached is the top part.

In the rear part of the wheel, on the driver's side, visualize the computer; place the top part of the armor on top of the computer, the part that holds the padlock looking for the wheel.

In most cases it is very easy to place it, but, keep in mind that in some cases you have to move the cables a bit to get them in their place, and the other case some mechanics place cable ties on the screws that hold the computer for hold the cables (if so, you must cut the able ties so that you can enter the top of the armor)

If you have already installed the top part, you must get under the truck, visualize the armor, and place the bottom part.

Keep in mind that the two pieces have a pad that cushion the vibration, for that reason you must tighten the two pieces to place the padlock, (remember that the padlock must be open to put it in place, the padlock enters very tight) (remember to close the padlock and remove the keys) in most cases this process only lasts 5 minutes.